Forecabin with vanity and sink, lockers, shelves and hanging locker
Furniture grade main cabin settees and seats with contoured cushions
Main cabin with cherry hardwood cabinets throughout
Large storage outboard of main cabin seatback
Drop-leaf centerline table with table storage
Full navigation station aft to port Navigation locker with storage space for extensive electronic installation (3) drawers and tube chart storage
Aft cabin with a double berth, hanging locker and shelves
Storage below berths.
(2) Helmseat storage lockers.
Propane gas storage for two tanks.
Hinged storage on top of engine box.
Cockpit seat locker port.
Main cabin settee, converts to double.
Jensen Stereo with cockpit speakers
White NPG/ISO gelcoated hull, hand laminated with alternating layers of strand mat and uni-directional "E" glass locally reinforced. Fully cored with high strength, impact resistant synthetic core for stiffness with solid glass at all thru hull, chain plate and keel installations. Gelcoat backup layer is laminated and chemically bonded using a 4mm barrier coat of vinylester anti-corrosive resin for blister resistance. 90º throw flush thru-hull fittings. Bulkheads and floor timbers are bonded using advanced adhesive technology. Built to meet ABS Plan Certification.
Keel #1 Keel Type: Beaver tail Ballast: 6200 lb Displacement: 16150 sq ft Max Draft: 5.00 ft
Fuel: 38 gal
Water: 80 gal (2 tanks)
Holding; 24 gal
3 burner Force 10 gimballed LPG stove with oven and broiler
Double stainless steel galley sinks
9" deep Molded top and front load ice box, 4" foam insulated
Built-in trash bin
Hot and cold pressure water and manual fresh water pump
80 gallon freshwater aluminum tank
Extensive lockers, shelves and dovetail drawers
38 Hp diesel with console mount controls and instrument panel.
White, off-white or sand gelcoated deck with patterned, contrasting non-skid.
Hand laminated sandwich composite of polyester resin, uni-directional "E" glass and end grain balsa core.
All hardware installation points are solid glass backed with aluminum plate or FRP backing plates. Joined to hull using stainless steel fasteners that are drilled and tapped into aluminum backing plates molded into hull flange, spaced to meet ABS specification for offshore sailing yachts. Bonded with 3M 5200™ sealant.
DINGHY MERCURY 270 SPORT GREY
Factory floor replacement 2016 with towing bridle
2012 Torqueedo travel 1003S
Cockpit stereo speakers new 2017
Group 27 batteries new 2017
2 Propane tanks new 2016, 2018
Dock lines, spring lines new 2018
Torgeedo battery (for dinghy) new 2018
Scheduled for new bottom pain finish by SSY Micron CSC Dark Blue 2018
The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.