Hull and superstructure:
Hull, deck, side decks and cockpit are made of fiberglass.
Color of hull white, bulwark and waterline dark green.
Wheelhouse assembly, rear wall, door and door frame teak wheelhouse ceiling made of glass fiber-reinforced polyester.
Pulpit, restraints and rear basket made of V4A steel wire rack with plastic cover and clamping screws. Bollard on the front and aft. Hand windlass with 40m galvanized chain and pool anchor 20 kg.
Mast trunks mounted with bolts on a 20 mm thick cast-steel plate and supported by the ballast.
Chain plates bolted to cast-in steel reinforcements in the outer skin and deck.
Mast trunks and chain plates stainless steel, masts and booms from gold anodized aluminum.
All mast and boom fittings stainless steel.
Halyard winches for jib and mainsail. Reef system.
Mainsail, staysail and mizzen provided from brown American diols with trimmable leeches, sail bags and battens.
Mizzen with two reefs..
Standing rigging in stainless steel wire.
On the edge of the cockpit two sheet winches with removable dicks, the winds in two stages executed .. Behind winds cleats for allocating the pod.
Electricity / Technology
Start battery 140 Ah, 140 Ah battery lighting
4 x 180 Ah
Automatic pressurized water system
Dirty Water Pump
Webasto heater with thermostat.
Seafarer echo sounder
Seafarer log and compass
Stainless steel sink
Burner stove with oven and grill, halbcaranisch
Hot and cold water mixer tap
Fridge 50 liters
In the front cabin, two berths of 2.00 m length
Port in the dinette sleeps 2 people.
Under the wheelhouse cabin for 2 people.
Toilet room with yacht toilet and shut off valves
Fixed basin with hot and cold water with mixer tap and shower
Water heater with exhaust outside.
2006: Full paint repair
2006: Frontshipbox new
2006: Conversion Dinett - fridge new
Boiler motor 220 V of Messrs. Rasmussen
2007: Electrical new
2207: Radio new
Compact charger Vetus new
2007: Steel rails (anchor points for chain plates + new rails V2A)
2008: Installation Vetus bow thruster and hydraulic system
2008: Complete hose system new
Water pipes in copper
2008: osmosis protective coating
2011/12: Engine Inspection - piston rings new-alternator-starter-nozzles and injection pump check
Dual circuit coolers new V4A
New batteries 4 x
2012: new wiper
212/13: Bullseye STB 2 x new for the quarter berth V4A
Deck hatch new V4A
2013: New Jabsko Electrical
Every year, two paint transitions and underwater hull fouling have been performed.