This beautiful Allied 42 XL-2 yawl has had only two owners in her life span. The first owner raced her extensively on Chesapeake Bay and off shore races, and sailed her to Europe and the Caribbean. the current owner purchased the vessel in 2005, and proceeded with a complete 4 year re-fit. Furly B has cruised the Maine coast from 2010 to present and has been offered for bareboat or crewed chartering under the watchful eye of her captain / owner.
Furly B's refit included: complete deck re-coring where needed, complete deck and hull Awl-Grip painting, bottom stripping and barrier coating, Complete system upgrades for mechanical, electrical and plumbing, including replacement Yanmar 40HP diesel, all new electronics including Garmin GPS / Radar, new full suit of sails, dodger and sail covers, and plenty more.
A beautiful, great performing yacht that turns heads in every port she visits, Furly B is easy to sail. She was designed by Sparkman & Stephens in the CCA era that favored good cruising and off shore characteristics while providing performance and windward ability. Her keel / centerboard configuration allows for perfect balance and access to shoal water cruising areas such as Cape Cod and the Bahamas, and her yawl rig spreads out the sail area and creates numerous combinations for shortening sail.
For one seeking a modern classic yacht in excellent, turn key condition, Furly B is highly recommended.
PRICE REDUCTION TO $ 95,000 MARCH 2017.
Call Dave Perry at 207-650-4167 or 207-371-2343
The cabin of Furly B is spacious, particularly for boats built in her era. She is finished in the Herreshoff style, meaning white bulkheads with varnished teak trim. This adds to her spacious feel and is easy to care for. The cabin sole is solid teak. There are two large overhead hatches, fitted with Skyscreen shade and screen system, 7 opening ports and two large dorade vents for great ventilation. All ports and fixed windows have curtains. A propane heater is mounted in the main cabin for wonderful warmth on chilly nights while cruising.
Because of a high bulkhead at the companionway replacing the need for a bridgedeck, entering the cabin of Furly B is easy. To port of the companionway is a very well laid out U shaped galley. In the forward section is a huge ice box with double hatches. A 12 volt Waeco Adler Barbour refrigeration system is efficient and trouble free. Outboard, in the middle section is a stainless steel 3 burner Force 10 Propane stove with an oven. The aft counter has a large sink served by hot and cold pressure water. Lockers for cooking and dining utensils and food stores are located outboard of the counters and under the sink area. All systems, including pump, faucets, stove and refrigeration were replaced during the major 05-09 refit.
To starboard of the companionway is a quarter berth, forward of which is a large navigation table. There is a drawer under the chart table and lockers both under and outboard for great storage of charts, navigation tools and equipment.
The main cabin is next forward. There are pilot berths port and starboard, outboard of two settee / berths. The starboard settee is "L" shaped, and converts to a double berth. The dining table is floor mounted and has drop leafs to reach each settee. Great storage areas include large lockers under the pilot berths, behind the settee backrest cushions.
Forward of the main cabin, to port, is a bureau with two drawers and a trap, and a locker above. A Force 10 Propane cabin heater is mounted in the alcove above. Next forward, to port of the passageway, is a large hanging locker.
To starboard is the head area. A vanity with sink and hot and cold pressure water and shower attachment is aft, and the marine toilet is outboard. An opening port and a dorade vent provide good ventilation.
Furthest forward is a comfortable V-Berth stateroom. There is a bureau with 3 drawers aft of the starboard berth, and a hanging locker aft of the port berth. There are drawers and lockers under the berths and a filler cushion converts the two berths to a double. A bi-folding door closes the stateroom from the passageway, enhancing privacy, and there is a door directly to the head as well. Ventilation is obtained via two opening ports and an overhead hatch, all with screens.
Single spreader rig
Aluminum main and mizzen masts and booms
Harken Jib Roller Reefing
Worm Gear back stay adjuster
Hall Spars Rigid Boom Vang
SS 1X19 standing rigging with Norseman Terminal fittings
Running rigging replaced 2010
Adjustable mainsheet traveler
Harken Mainsheet Fiddle Blocks
Full Batten Mainsail - Pope Sails 2010
Full Batten Mizzen - Pope Sails 2010
Lazy Jacks for both Main and Mizzen
130% Genoa Jib with tapered foam luff - Pope Sails 2011
Forespar Telescoping Whisker Pole
Inner Forestay with quick release lever & running back stays
Hank on Staysail for above rig
Hank on Storm Jib for above rig
Spare "short hoist" Genoa
Mizzen running backstays
# 62 Barient 2 Speed Self-Tailing Primary winches
Barient 2 Speed secondary winches
#40 Barient 2 speed Self Tailing cabin top winch (used for boom vang)
Cabin top Centerboard winch
Halyard and reefing winches on Mast
Main and Mizzen sail covers - Cadet Gray - Fortune Canvas 2010
Wheel / Binnacle cover - Cadet Gray - Fortune Canvas 2010
Spray Dodger with removable sides - Cadet Gray - Fortune Canvas 2010
Full Deck Awning
Garmin 4208 Color GPS /Chartplotter / Radar with split screen or overlay
Mounted in pod at the hem
4KW Hi Definition Radar Scanner mounted on mizzen mast
Garmin GMI 10 display on cabin bulkhead for Speed / Log / etc.
Garmin GMI 10 display on cabin bulkhead for Depth / Wind / etc.
Above can be switched to display wind direction / wind speed and position
Standard Horizon VHF radio with RAM mike at helm
Raymarine Wheel Autopilot
All above instruments installed in 2010
40 HP Yanmar 3JH3 Diesel 2001 -- installed 2009
Fresh Water cooled
Yanmar transmission 2009
New shaft, cutlass bearing and stuffing box --2009
Pedestal mounted engine controls -- 2009
Edson Pedestal Steering -- rebuilt 2009
Racor Fuel / Water Separator Filter
Groco Seawater Intake Filter
Monel 27.5 gal fuel tank
12 Volt DC Ship's electrical system
2 group 27 AGM Batteries - total 210 amp hours - house bank (2009)
1 Group 27 AGM battery -- 105 amp hours -- engine start (2009)
Battery Bank selector switchs
Battery Bank Isolator
Circuit breaker panels - (2009)
100 amp Balmar Dual Output Alternator (2009)
Balmar Smart regulator (2009)
Automatic Electric Bilge Pump
High Bilge Water Alarm
8 Brass Swivel LED Cabin Lights
Red / White LED Chart Light
Deck Light on Mizzen Mast
12 volt DC outlets at Helm, Nav Station, and V-Berth Stateroom
Domestic water pump
Sealand Holding tank discharge pump
Seawater washdown pump
Shower sump pump
Waeco Adler Barbour 12V Refrigeration
2 Solenoid switches for propane system
120 volt AC Shore Power System
50' and 25' Shore Cords
120VAC Circuit breaker panel - (2009)
120 VAC outlets in galley and head compartment
6 gallon SS Water Heater (2009) Water also heated by engine heat exchanger
Hot and cold pressure water system
Shur- Flow water pump
Faucets at galley and head areas (2009)
Manual Fresh Water Faucet at Head Sink
Telephone type Shower Nozzle in Head area
6 Gallon SS water heater
2 Monel water tanks - total 80 gallons
Electric Automatic Bilge Pump
Shower Sump Pump
Wilcox "Skipper" Manual Marine Toilet
25 Gallon Holding Tank
Sealand Electric Overboard Discharge Pump for holding tank.
All sanitation hoses replace (2009)
Seawater washdown system at bow
Anchor roller at bow
Simpson Lawrence 555 Sea Tiger Manual Anchor Windlass
45# CQR Anchor - 180' BBB Chain - 60' Rode - primary anchor
20H Danforth Anchor - 20' Chain - 200' rode - secondary anchor
40S Danforth Anchor - 15' Chain - 200' Rode - storm anchor
Bow and Stern Rails
Double Life Lines and Port and Starboard Gates
SS Boarding / Swim Ladder at Starboard Gate
Teak Toe Rails, Coamings and Cabin Trim
Horseshoe Type IV Throw Ring
First Aid Kit
3 Fire Extinguishers
Auto fire extinguisher in engine room
6 Life Vests
4 Large Fenders with polar fleece covers
8 3 Strand Nylon Dock Lines
1 1/2" Henderson Manual Bilge Pump mounted in cockpit
Auto Electric Bilge Pump
High Bilgewater alarm
Lightning ground protection installed per ABYC Standards
Magma Rail Mounted BBQ Grill
Furly B under went a full top to bottom re-fit between 2005, when the current owner purchased her, and 2010 when she was first launched. This work included"
Deck: Removal of all hardware, teak coamings, toe rails and hand rails, re-coring of many areas on deck as needed, sanding all surfaces and removing the non-skid to smooth. The priming and Awl-Grip painting the completed deck in Matterhorn White, and Gray Non Skid areas. All teak components were coated with West System Epoxy on their feign surfaces for attachment to eliminate water intrusion, and bedded with 3M 4000 sealant. The teak trim is finished in Sikkens Cetol Natural.
Hull: Removal of old rub rail below the shear and filling all attachment areas. The bottom was stripped of old antifouling paint, filled and faired as needed, and coated with Interprotect 1000 / 2000. then finished with 1 coat of blue tracer anti-fouling and 2 coats of Pettit Ablative Black. The hull topsides were faired and finished in Awl-Grip Stars and Stripes Blue, with white boot and cove stripes.
Systems: The former Westerbeke engine was removed, the engine area cleaned and painted and new engine mounts built. The new engine installed is a 2001 Yanmar 40 HP 3JH3 fresh water cooled diesel that had 30 hours of operation on it when purchased. (had been installed as a come home engine in a powerboat. The transmission was new as the former system did not use a mechanical transmission) All engine mounts, shaft, cutlass bearing and stuffing box were replaced, along with controls at the pedestal. The electrical systems were completely replaced and upgraded with new panels and wiring to ABYC standards. All new pumps were installed, the marine toilet was overhauled, and sanitation hoses were replaced as part of the refit. The propane system is completely new, including two vapor tight tank lockers on the aft deck, 3 10# Aluminum tanks, hoses with independent solenoid switches to each appliance, sniffer, and new Force 10 Propane Stove and Cabin Heater.
Rigging and equipment: Furly B had very good sailing equipment that had been updated by the previous owner, such as the winches, furling gear, and new rigging. Under her new ownership sails were replaced, along with all new running rigging and sheets. All gear such as fenders, docklines, ground tackle and life vests are new, plus the galley systems of refrigeration and stove, the cabin heater, and much, much more.
The current owner of Furly B is a former Yacht Yard manager and a qualified mechanic and electrician. He was very familiar with the wonderful lines and sailing characteristics of the Allied XL 42 because he had owned a sistership yawl in the mid 90's. In a desire to own one again, he ideally wanted to find one that needed a total re-fit / restoration, where all work required would meet his standards and expertise. This was found in Furly B, as she was still with her original owners who had worked with Allied Boat Company and Olin and Rod Stephens directly in building the boat. She had a glorious history of racing and cruising, and had crossed the Atlantic and sailed in the Caribbean.
Other than a hanging lamp that may appear in several pictures, all items aboard convey with the vessel. Furly B is fully found including dishes, silverware, cooking utensils, tools, manuals, and many spare parts.
Robinhood Marine Center
340 Robinhood Road
Georgetown, ME 04548