Built in 1965 by Hillyards, This 20 ton ketch was built to order for a gentleman who specified a higher quality boat than Hillyards normally built, which included the use of teak in all of the coachroof and dog house coamings, plus a taller rig for increased performance. Extensive and thorough refit in present ownership including new rig, engine and systems. She is now a first class yacht, fully equipped with everything required for long distance cruising or comfortable live aboard. It would be hard to find a better Hillyard or a more comfortable and spacious yacht of this length.
Contact: Richard Gregson on 01803 833899/ 07886081657
Bermudian ketch. Part 1 registered Lying Kent
Designed and built by David Hillyard of Littlehampton, 1965.
Hillyard’s Yard was probably the most successful yacht builder in UK until the advent of GRP. David Hillyard started building small yachts in the 1920’s and quite early in his career hit on the centre cock-pit design which became his trademark. The classic Hillyard is a long keeled yacht with canoe stern and short over-hangs with a deep, safe centre cock-pit, often sheltered by an open backed dog-house.
The centre cock-pit allowed a three compartment lay-out with an aft cabin, a midships saloon cabin and a forward cabin - rare to have more than 1 separate sleeping cabin except in much larger yachts.
Safety and comfort were more important than speed to his clientele and the yachts became very popular especially with families and cruising people.
He built the design in various sizes from the most popular 30’ 9 tonner, the successful 36’ 12 tonner and a few larger yachts built to specific request. Individual requests were catered for and there were variations on the theme. Most were round bilged, a few built with a chine to increase the cabin sole area and therefore internal volume, some with steel plate bilge keels bolted on and at the end of the period a few built with a transom stern instead of the standard canoe stern.
This is one of the larger Hillyards and probably one of the best. She was built for an experienced owner (his fourth Hillyard) who specified all teak brightwork 9(unique for post-war Hillyards, taller masts and improved interior joinery.
Length on deck 42’
Typical centre cock-pit Hillyard design with a long keel, canoe stern, powerful high bow and a chine to the bilge.
Planked in 1.25” mahogany, all copper fastened to 3.5” x 2” sawn oak frames at 35”c with two 2” x 2” @ 13” steamed intermediate timbers.
Oak back-bone. Oak floors
Long external iron ballast keel. Internal lead trimming ballast.
The deck is laid in T&G pine set fore and aft on the fore and after decks and laid diagonally on the side decks. All sheathed in Cascover (a nylon cloth with Cascophene rescorcinol glue) and painted light grey.
Heavy teak rubbing strake all round the deck edge with 4” teak toe rail and capping over.
Typical Hillyard safe, strong, high galvanised gas pipe railings all round with a gate each side.
The deck structures consist of a centre cock-pit with a fixed open backed dog-house over, coach-roof forward up to the main mast over the saloon cabin and coach-roof aft over the aft cabin. The forward coachroof was renewed in 2012.
The coach-roof coamings and dog house are built in teak. The coach-roof decks are in T&G pine, epoxy sheathed with teak grab rails each side.
All new toughened glass windows, opening sections each side of the fwd coach-roof, 2 small rectangular fixed lights each side in the after coach-roof.
Low level fore hatch on the fore deck.
Aft hatch on the aft coach-roof deck.
Teak gas bottle box on the aft deck behind the coach-roof.
Massive oak Sampson post on the fore deck and on the aft deck.
Heavy cast steel bitts each side on the fore and aft deck take the mooring lines.
Galvanised fair leads on the rail forward and aft.
Twin chain roller galvanised stemhead fitting.
Wheel steering on cables from the port side traditional spoked wheel in the cock-pit to the usual Hillyard galvanised quadrant on the rudder stock under the aft deck, accessed through the aft cabin.
Bermudian ketch rig on varnished rectangular section built spruce masts, re-glued in 2012.
The main mast is stepped in a galvanised tabernacle on the deck immediately forward of the forward coach-roof.
The mizzen mast is stepped in a smaller galvanised steel tabernacle mounted on a hardwood block on the aft coach-roof.
All new s/s standing rigging and rigging screws set up to external galvanised steel chain plates, regalvanised and refastened 2012.
The main mast has twin lowers and cap shrouds round single varnished spreaders. Removeable inner forestay for staysail/storm jib.
Split standing s/s back-stay.
Fore stay on ne Harken roller furling gear.
Single halyards from the spreaders each side.
New Tri colour light and VHF ariel at the masthead.
Cleats on the tabernacle and on the mast.
Main boom, rectangular section varnished spruce with slab reefing, sheeted to a car on an aluminium track across the aft coach-roof with modern blocks, jammer cleat on the lower block, all accessible from the cock-pit.
Bronze track on the forward face with traveller ring to take the spinnaker pole.
External bronze mainsail track.
Varnished rectangular section mizzen mast and boom.
Sheeted to the stern post head, the tail led back in to a cleat on the tabernacle.
Twin lowers and cap shrouds, all in new s/s wire with s/s bottlescrews to external galvanised chain plates (regalvanised and refastened 2012).
Single spreaders and jumper strut to stiffen the upper section of the mast.
All new running rigging.
Pair of new Harken self tailing winches on the main mast.
1 x Harken single speed winch on the mizzen mast.
Pair of new Harken 46 ST 2 speed genoa sheet winches on the cock-pit coamings.
Fully battened mainsail with integral stackpack and lazy jacks – Northrop sails, new 2012.
Furling genoa – Arun Sails, age unknown. Valeted and repaired as necessary.
Staysail – Stephen Ratsey 2009
Mizzen – Northrop Sails – new 2012
Storm jib – Northrop Sails – new 2012 (set on removeable inner forestay)
Spinnaker and mizzen sail – Ratsey, age unknown.
Beta Marine 75hp diesel, new 2012.
Centreline installation with conventional shaft drive to centre line 3 blade prop. New SS shaft.
Newage PRM 260 single lever controlled gear-box.
Gear-box oil and engine oil evacuating pump. Bowman heat exchanger and oil cooler.
Full engine instrumentation at the helm.
New sound proofing in the engine bay.
Primary (Racor) and secondary fuel filters both easily accessed from the side inspection panel.
The engine is installed immediately below the cock-pit with the passageway aft to stbd.
The engine is accessed by removeable panels in the passageway or by removeable panels in the saloon and aft cabin.
Eberspacher hot air heater with ducting to 3 outlets.
2 banks of new 2 x 12v batteries.
12v engine start and 12v ship’s supply.
Heavy duty, twin belt driven alternator + second 65amp alternator driving Cometic 3.5kva inverter, providing 240v supply
Mains 240v supply with consumer unit..
Manuals for the engine and all equipment on board.
Sterling ProCharge Battery charger.
Water: 2 x Vetus under saloon floor. 450 litres.
Fuel: 2 x Vetus under saloon floor. 670 litres.
6 berths in 3 sleeping cabins + saloon.
Fore peak with single berth to port, rope, sails and general stowage.
Centreline bulkhead door to the forward cabin. Generous port and stbd berths in nice varnished mahogany joinery; Deep, drop down bunk-boards, lockers and drawers under the berths.
Slightly stbd off-set bulkhead door, tall thin hanging locker on the centre-line against the bulkhead.
Galley to port with Taylors 2-burner, grill and oven gas cooker, rebuilt 2012, stainless steel sink in scrubbed teak work surface. Cupboards and shelves above and below. Port hole over the cooker. Air extractor fan on the deckhead. New Pilot twin-sensor gas alarm.
New Waeco Coolmatic fridge in galley with auto 12v/240v change over switch.
Heads compartment to stbd opposite the galley with new Lavac sea toilet and stainless steel basin in a white formica surface along the ship’s side. Port hole above, locker under.
Centre-line steps up to the sunken deck saloon.
U-shaped seating to port around a large mahogany table with cupboards built into the legs under.
Lockers behind and under the seating.
Chart desk in the fwd stbd conrer, forward facing, bench seat in front.
Lockers along the stbd side under the side deck with nice varnished mahogany panelled doors.
3 steps up to the cock-pit, twin panelled mahogany doors, slight duck-down for tall people.
Aft cabin entrance in the after stbd corner of the saloon cabin, step down and stoop down into the passageway.
Removeable panel to access the engine, lockers under the side decks.
Large aft cabin with port and stbd generous berths.
En suite heads compartment in the fwd port corner with new Lavac sea toilet, stainless steel sink and shower. Varnished teak floor panel lifts to reveal teak grating over the stainless steel shower tray.
Ventilation/escape hatch in the deckhead.
Removeable panel above the feet of the berths to access the steering cables.
All berths minimum 6’1 with good bunk boards.
6’1” head-room in aft cabin and saloon cabin. 2” less fwd.
Electric lights and Tannoy vents in fwd and after cabins.
New fuel and water tanks under the saloon cabin sole. New pressurised water supply and calorifier with mains immersion heater.
New Vetus holding tank for toilets.
Sestral major steering compass (serviced 2012)
Standard Horizon chart plotter
NASA wind direction/speed
NASA depth sounder
New Raymarine SP30 autopilot (rotary drive to wheel)
35lb CQR & 30lb Fisherman anchors
30 fathoms 12mm chain, regalvanised 2012.
Duer Torkmaster hydraulic windlass with manual over-ride on foredeck. Rebuilt 2012, dedicated 2x12v batteries in forecabin
Sail covers. Mizzen cover new.
New hatch covers fore and aft, anchor winch cover.
New all weather cockpit cover with SS frame
New saloon seat and bunk cushions
12v anchor light
Pair wooden beaching legs
Fenders, warps, boarding ladder
2 Southford Road