Updated Price Upon Request
Due to recent updates and scheduled maintenance, the sale price has been modified from $50,000, please call for details.
Proposed work involves:
The beautiful yawl "Evening Star" was built in 1937 for Frederick Ford of Detroit at Bristol, Rhode Island.
This top quality yacht was built using only the finest materials and hardware, and proven traditional techniques.
Her restoration began in 2011, and most of the work has been completed (see listing for more details). The transom was replaced and the entire deck frame and deck as well. The hull remains in excellent original condition. All of the hardware and interior trim was carefully removed and stored for re-installation.
Currently installing the teak deck and all topside hardware including spars and booms, combing, winches, traveler for main sheet, coffee grinder, anchor windlass,bow pulpit, running backs, etc. Cabin sole frame and new partial flooring along with interior work and new fuel tanks.
Alden Design No. 638 - See link to design informatio later is listing.
Herreshoff Build No. 1386
Additional photos available.
The Evening Star is quite special, being a John Alden design and also being built by the Nathaniel Herreshoff yard. The very high quality of the boat made the decision to restore less risky for me.
We bought the boat in 2011 from the Oakland Yacht Club in Alameda at a sealed bid auction. The boat had been neglected for several years and looked very beat up. I looked at the lines of the hull and the fairness of the planking and noticed that there were no rust bleeders or any hogging of the sheer line. However, the transom was rotten at the deck line and the teak deck was showing looseness by missing plugs and protruding screw heads.
We won the boat at the auction and then went to work. We had the boat towed to a boat yard and hauled out for 4 ½ months. We stripped the hull to bare wood and re-built the transom.
During the haul-out we fixed the diesel engine and shaft and plugged off 13 thru hull fittings with cedar plugs. We also removed truck loads of horrible plumbing and wiring.
We motored the boat to a slip at a working wharf called Sugar Dock, where it is today. We recovered the cabin top with burlap and arabol and removed all of the deck hardware. We carefully numbered and removed the teak deck, which we saved, and then determined that the deck frame was not fixable. After deciding to continue with the work, we removed and labeled the interior trim and doors and proceeded with the new deck frame.
The new marine plywood deck is three layers of meranti plywood glued and bronze fastened to a laminated frame of clear Alaskan yellow cedar.
The next job I was going to do was to jack up and reglue the partitions that have pulled apart, scrape and primer the interior, then scrape and paint the bilge, then reframe the cabin sole and put in new flooring except for the salon which is still good.
The salon floor has a large removable hatch for the removal of the two copper water tanks under the floor. These tanks are in good condition and have been drained. The boat needs new fuel tanks.
Other work needed includes repairing the interior partitions in the heads and between the engine room and the master cabin. After the rough work, all of the interior trim and doors, drawers, cabinets, etc. could be reinstalled.
I was planning on reframing the cockpit floor to attach to the hull and remove the problem of reverse crowning. The masts should be pulled and varnished and the rigging inspected or replaced and of course install the bowsprit and bumkin spars after varnishing. The boat would now be essentially restored.
I expected the above mentioned work to take another year of my time and cost about $50k with me doing the labor.
P.O. Box 203
1 Main St.
Rockport, ME 04856